Zanussi ZOS35802XU Manual De Instrucciones página 49

Step 1
Turn off the oven. Wait until the
oven is cold.
Back lamp
Step 1 Turn the glass cover to remove it.
Step 2 Clean the glass cover.
Step 3 Replace the lamp with a suitable 300 °C heat-resistant lamp.
Step 4 Install the glass cover.
12. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
12.1 What to do if...
Problem
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The display shows "12.00".
The lamp does not operate.
Steam and condensation settle on
the food and in the cavity of the
oven.
There is water inside the oven.
The indicator is off.
Before you replace the lamp:
Step 2
Disconnect the oven from the
mains.
Possible cause
The oven is deactivated.
The clock is not set.
The necessary settings are not set.
The fuse is blown.
There was a power cut.
The lamp is defective.
You left the dish in the oven for too
long.
There is too much water in the tank.
There is not enough water in the
tank.
Step 3
Put a cloth on the bottom of the cav‐
ity.
Remedy
Activate the oven.
Set the clock.
Make sure that the settings are cor‐
rect.
Make sure that the fuse is the cause
of the malfunction. If the fuse is
blown again and again, contact a
qualified electrician.
Reset the clock.
Replace the lamp.
Do not leave the dishes in the oven
for longer than 15 - 20 minutes after
the cooking process ends.
Deactivate the oven and wipe the
water with a cloth or sponge.
Fill the tank with water until the indi‐
cator comes on. If water starts to
come out inside the oven, and the
indicator is still off, contact a quali‐
fied service engineer.
ENGLISH 49