Haier HAH64EXCP Manual Del Usuario página 62

4.- Before pass 30 seconds after switch on the
hob; touch for 5 seconds "-" key of timer.
5.- After this moment, this message will appear
on display, Po on timer display. Power level
divided by 100 in heater displays.
6.- Using '+' and '-' of Timer keys, Power
Management value can be adjusted. When
required value is selected, touch at the same
time "+" and "–" keys during 5 seconds.
7.- When this process is finished, a long beep is
heard and a reset is produced. Start-up
process will be generated again.
8.- After start-up process, in timer display power
management will be showed.
After that, touch control won´t allow any
combination which can exceed this limit.
Notes:
a) This power management is only available
during first 30 seconds after switch on the
hob.
b) If this power management selection is ON, if
more than 90 seconds after switch on the
hob this process will be finish without any
new power value were recorded.
c) If this power management selection is ON, if
any key is touched except the combination
of timer "+" and "–", process will be finish
without any new power value were recorded
and touch control will start working as usual,
without reset.
d) If this power management selection is ON, if
any key is touched the combination of timer
"+" and "–", process will be finish with a new
power value were recorded , reset and touch
control will start working as usual.
Switch ON/OFF a heater zone
To switch ON a heater Touch power key during
400 msec. Long beep will be heard and "0" value
will appear in target zone digit, indicating power
level.
1) If any cooking stage is in position 0, this
display will switch OFF automatically after 10
seconds and the zone OFF sequence will
sound.
2) If there is residual heat indication in the
display which is ON but in 0 power, "0" will
appear changing over.
3) If lock function is active you cannot switch ON
a zone.
To switch OFF a heater Touch power key during
1,2 sec. 3 Short beeps will be heard and nothing
or "H" value will appear in target zone digit if
residual heat exists. Zone will be OFF.
1) If any cooking stage is in position 0, this
display will switch OFF automatically after 10
seconds and the zone OFF sequence will
sound.
GB 62