Heiniger ORION Instrucciones De Manejo Originales página 27

5 Transport, packaging and storage
Check the delivery on receipt immediately on completeness and damage in transit.
NOTE!
Complain any damage as soon as you discover it. Claims for damages only may be
made within the valid time.
For the packaging, just non-polluting material is being used.
The packaging is to protect the individual components from transport damage, corro-
sion and other forms of damage prior to use.
Store the clipper and accessories as follows:
Always store in the packaging supplied with it.
X
Do not store outdoor.
X
Store dry and dust-free.
X
Protect against solar irradiation.
X
Avoid mechanical shocks.
X
Storage temperature: 0 until 40°C.
X
Relative humidity: max. 75%. When storing longer than 3 months, check periodically the gen-
X
eral condition of all parts. If necessary, refresh or renew the conservation.
6 Operation
WARNING!
Incorrect operation may cause damage on persons or objects. Therefore:
y Do all the steps of operation according to the indications in this instruction manual.
6.1 Initial start-up
6.1.1 Setting up the charging station
y Observe all technical data according to the operating conditions (3 Technical data).
y The installation surface must be even and must dispose of sufficient stability and payload.
y The location of installation must be protected against humidity and rain.
y Power outlets in the outer area must be equipped with a residual current circuit breaker (FI).
y The workplace must dispose of sufficient illumination and ventilation.
y The location of installation must be out of reach of children.
Fig. 10
3. Place the clipper, with the battery inserted, in the charging station so that the upper part of the
clipper is facing towards you and the contacts on the clipper are resting against the contacts
of the charging station. The part with the switch is the upper part of the clipper.
4. During the charging process the LED indicator lamp stays lit red continuously. Once the
charging process is complete the LED indicator lamp stays lit green continuously. and the
clipper is ready to use. This charging station has an LED indicator lamp.
Translation of the original instructions / Hair clippers
1. Place the charging station on a firm, even, dry, clean
and free underground.
2. Plug the charging station in the power outlet.
11