Publicidad
Idiomas disponibles
Idiomas disponibles
Polaris
Robotic Pool Cleaner | Owner's Manual
®
Section 5. Maintenance
WARNING
To avoid electric shock and other hazards which could result in
permanent injury or death, disconnect (unplug) the cleaner from the
power source before performing any cleaning and maintenance.
5.1
Cord Tangling
Tangling can occur more frequently when the cleaner
is not attended to after each cleaning cycle. Proper
installation, general maintenance and the following
troubleshooting steps can help to avoid cable
challenges.
IMPORTANT
Cleaner power cable may become tangled if correct procedure is not
followed after each cleaning cycle.
NOTE: Place all of the floating cable in the water to allow
free movement in your pool from the central point.
Spread out the floating cable ensuring there are
no kinks or coils in the cable.
Cleaner
Cleaner
Do not use an extension cord.
Figure 7.
Optimal Entry Point in Pool
If tangling occurs, follow these steps:
1.
Remove the cleaner from the pool. When the
cleaner is within arm's reach, use the handle to
remove from the water. Never lift the cleaner out
of the pool by the floating cable.
2.
Hold the cleaner vertically to drain.
Not Recommended
Caddy /
Control Unit
Recommended
Entry Point
WARNING
Figure 8.
Keep Cleaner Vertical to Drain Water
3.
Unplug power to the cleaner at the control box.
Figure 9.
Unplug
4.
Remove the cleaner from the pool and untangle
all kinks and coils in the power cable. Start at
the cleaner head. Lay the cable in the sun to
loosen any tangling memory.
Figure 10. Untangle the power cable
ENGLISH
Page 9
Publicidad
