Goodwe MS Serie Guía De Instalación Rápida página 4

EN
Product:
1. Do not apply mechanical load to the terminals, otherwise the terminals can be damaged.
2. All labels and warning marks should be visible after the installation. Do not scrawl, damage,
or cover any label on the device.
3. Unauthorized dismantling or modification may damage the equipment, the damage is not
covered under the warranty.
4. Install the inverter away from high magnetic field to avoid electromagnetic interference.
If there is any radio or wireless communication equipment below 30MHz near the inverter,
you have to:
• Install the inverter at least 30m far away from the wireless equipment.
• Add a low pass EMI filter or a multi winding ferrite core to the DC input cable or AC
output cable of the inverter.
5. Warning labels on the inverter are as follows.
HIGH VOLTAGE HAZARD.
Disconnect all incoming power
and turn off the product before
working on it.
Read through the guide before
working on this device.
High-temperature hazard. Do
not touch the product under
operation to avoid being burnt.
CE marking
Check before Power-on
No.
The product is firmly installed at a clean place that is well-ventilated and easy-to-
1
operate.
The PE, DC input, AC output, and communication cables are connected correctly and
2
securely.
3 Cable ties are intact, routed properly and evenly.
4 Unused ports and terminals are sealed.
The voltage and frequency at the connection point meet the inverter grid connection
5
requirements.
Delayed discharge. Wait 5 minutes
after power off until the components
5min
are completely discharged.
Potential risks exist. Wear proper
PPE before any operations.
Grounding point. Indicates the
position for connecting the PE cable.
Do not dispose of the inverter
as household waste.Discard the
product in compliance with local
laws and regulations, or send it back
to the manufacturer.
Check Item
2