Skil BW9501-00 Manual Del Propietário página 14

Installing The Saw Table Assembly (Fig. 4 & 5)
a. Remove the hex bolt, flat washer, spring washer and wing nut from the saw table.
b. Align the slot on the saw table with the blade and slide the saw table around the blade from
the right side of the saw to the left as shown in Fig. 4.
c. While holding the saw table with your left hand, pull the angle adjustment knob away from
the saw frame (1), match the teeth on the saw table bracket with the teeth on the angle
adjustment knob. Release the knob (Fig. 5).
d. Fit the two pins on the frame into the slot in the saw table bracket (2).
e. Place one flat washer onto the threaded end of the first table lock knob, then repeat another.
Secure the saw table bracket to the saw frame by turning the two table lock knobs clockwise
(3).
f. Loosen the two table lock knobs, and turn the angle adjustment knob to ensure the saw
table can tilt smoothly. Then retighten the two lock knobs.
g. Tighten the screw on the scale indicator using the included combination tool.
h. Attach the hex bolt, flat washer, spring washer and wing nut to the saw table as shown in
Fig. 4.
NOTE: The wing nut goes below the saw table.
Fig. 4
Hex Bolt
Flat Washer
Spring Washer
Wing Nut
Fig. 5
2
Slot
Angle Adjustment Knob
14
Saw Base
Pin
1
Scale Indicator
Saw Frame
Saw Table
Flat Washer
Table
Lock
Knobs
3
3