Silvercrest SAS 7.4 LI D3 Guía Breve página 13

■ Important: The charge indicator lamp
handheld vacuum cleaner is charged enough to vacuum again. This does
not mean that all the batteries are completely charged. When the charge
indicator lamp
■ When charging is complete, which can take around 5 hours with fully dis-
charged batteries, the appliance automatically switches to a trickle charge
(maintenance function). Nevertheless, in order to avoid possible damage
to the batteries, do not leave the appliance permanently connected to the
mains adapter
■ Do not recharge the batteries again until the handheld vacuum cleaner's suc-
tion power becomes appreciably weaker and the charge indicator
lamp
NOTE
► If the battery is completely discharged, the appliance switches off and
the charge indicator lamp
60 seconds. Start charging the appliance.
► The handheld vacuum cleaner can also be charged directly via the mains
adapter
the wall bracket
plug
Operation
CAUTION!
► The suction opening must always be open and may not be blocked.
Blockages lead to overheating and damage to the motor.
► The appliance is not protected against splashes. You should therefore only
vacuum liquid up until the dirt container
NOTICES
► Make certain that the dust filter
appliance.
1) Remove the handheld vacuum cleaner from the wall bracket
not using the wall bracket
2) If required, place the appropriate nozzle in the suction opening:
–
the crevice nozzle
–
the wet suction nozzle
3) To switch the appliance on, slide the on/off switch
indicator lamp
4) When you have finished using the appliance, slide the on/off switch
the rear.
■ 10 │ GB │ IE
7
lights up green, the batteries are charged to around 80%.
4
.
7
flashes green.
7
4
. To do this, remove the barrel plug
3
and the cable from the cable routing. Insert the barrel
5
into the socket on the handheld vacuum cleaner.
3
2
, to clean narrow and difficult to reach locations.
1
7
lights up green.
7
lights up green once the
flashes green/red alternately for approx.
5
with a slight twist from
q
is filled to the MAX mark!
0
is always inserted before using the
remove the barrel plug
to vacuum up liquids.
6
3
or, if you are
5
from the socket.
forwards. The charge
6
to
SAS 7.4 LI D3