RIDGID HD1280 Manual Del Usuario página 4

INTRODUCTION
TOOL NEEDED
Phillips Screwdriver
UNPACKING
This Product Requires Assembly.
Check all parts from carton against the Carton Contents List.
If any parts are damaged or missing, contact 1-800-4-RIDGID
(US and Canada) or by email at info@ridgidvacs.com.
CARTON CONTENTS LIST (Fig. 1)
Key Description
A* Detachable Blower .......................................................1
B* Powerhead Assembly .................................................1
C* Dust Drum Assembly .................................................1
D* Drain Cap ......................................................................1
E Caster Foot w/Storage .................................................4
F Caster ...........................................................................4
G Pan Head Screw, #10 x 3/4" (19 mm) .......................4
H* Qwik Lock™ Filter .......................................................1
I Tug-A-Long Positive Locking Hose with Dual-Flex ...1
J Filter Bag ......................................................................1
K Extension Wand ...........................................................2
L Blower Wand ................................................................1
M Car Nozzle ....................................................................1
N Utility Nozzle .................................................................1
O Wet Nozzle ...................................................................1
P* Accessory Caddy .........................................................1
Q Owner's Manual ...........................................................1
* These parts come preassembled.
D*
D
G
Qty
Fig. 1
A*
B*
A
C*
I
L
B
E J
M
C
F
K
N
E
H*
L
O
F
I
M
P*
G
J
K H
N
Q
ASSEMBLY
CASTER/CASTER FOOT ASSEMBLY (Fig. 2)
NOTE: Remove Powerhead Assembly (B) from Dust Drum
(C) prior to assembly of Casters and Caster Feet.
1. Place Caster Foot (E) upside down on the floor.
2. Place the Caster (F) into the Caster Foot (E): Insert the
Caster Stem into Caster Foot Socket.
3. Push on the Caster Foot (E) until the Caster Ball end
snaps fully into the Socket and the Caster swivels freely.
Repeat for other Three Casters and Caster Feet.
4. Turn Dust Drum (C) upside down on floor.
5. Place Caster Foot (E) with Caster over Drum Post and
press firmly in place. Repeat for the other Three Caster/
Caster Foot Assemblies.
6. Four Screws are available for optional assembly of the
Caster Feet (E) into the Dust Drum (C). If desired, locate
the Four #10 x 3/4" (19 mm) Pan Head Screws in loose
parts bag. Insert a Screw (G) through the Caster Foot
Hole and into the Dust Drum (C). Tighten securely.
7. Turn the Dust Drum (C) upright.
Caster Stem
(3)
(E)
Caster Foot
Socket
(C)
Drum Post
4
Fig. 2
(F)
(G)
Caster Foot Hole