Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
POWERHEAD ASSEMBLY (Fig. 3)
1. To Attach the Powerhead Assembly to Dust Drum:
Place Powerhead Assembly (B) on top of Dust Drum
(C) with the Extended Lip of the Lid aligned with the Vac
Inlet Port. Be sure Powerhead Assembly is fully seated
on the Dust Drum.
2. Press in on the Two Latches, located on either side of
the Dust Drum (C) until they snap into place, securing
the Powerhead Assembly to the Dust Drum.
3. To Remove the Powerhead Assembly: Pull out on the
Two Latches and lift Powerhead Assembly (B) from the
Dust Drum (C). Do not force the Latches to rotate more
than slightly outside Drum flange.
(B)
Drum
Latch (2)
(C)
INSERTING THE TUG-A-LONG POSITIVE
LOCKING HOSE WITH DUAL-FLEX (Fig. 4)
1. Locate the end of the Tug-A-Long Positive Locking
Hose with Dual-Flex (I) and align it with the Vac
Inlet Port. Align the Hose Locking Tab with the
Vac Inlet Ridges. Push the Hose end straight into
the Vac Inlet Port until the Hose Locking Tab fully
engages the Inlet Ridges.
2. To Remove Hose: Rotate the end of the Tug-A-
Long Positive Locking Hose with Dual-Flex (I)
in either direction to release the Hose Locking Tab
from the Vac Inlet Port. Press the Hose Locking
Tab and pull the Hose end straight out of the Vac
Inlet Port.
Fig. 3
Hose Locking Tab
Vac Inlet
Port
INSERT HOSE
5
Fig. 4
Inlet Ridges
Vac Inlet Port
(I)
REMOVE HOSE
Publicidad
