Heiniger Libertas T-Trimmer Manual De Instrucciones página 37

Cleaning the cutter head
The cutter head should be thoroughly cleaned once a day if used regularly.
1. Switch the trimmer off.
2. Carefully remove hair on the cutter head using the cleaning brush.
3. It is recommended that the cutter head is removed regularly to so that the rest of the hair can
be removed from inside.
– For this, remove the screw using the Allen key and take off the cutter head (Figure E).
– Push the upper and lower blades slightly apart and also remove the hairs between the put-
ting plates on all sides using the cleaning brush (Figure F).
– Remove any possible remaining hair from inside.
4. To attach the cutter head hook it in underneath first of all and then attach it again using the
Allen key.
Oiling the cutter head
The cutter head must be regularly oiled, ideally every day, at the comb and contact surface. Only
use the original oil for this. Clean the cutter head before oiling it.
1. Oil the comb (Figure G).
2. Then oil the rear contact surfaces.
You can order the oil used for this from your Customer Service.
Cleaning the trimmer
Wipe your trimmer using a damp cloth occasionally and then rub it dry.
34 ENGLISH