Heiniger StyleMidi Manual De Instrucciones página 23

4.2 On/Off switch - LED colours
The colours of the On/Off switch 1 indicate the charging state of the battery dur-
ing operation and charging:
Colour
Red
Yellow
Green
4.3 Adjusting the cutting length
NOTE: only use original accessories!
Adjusting the cutter head
– The cutting length of the cutter head 3 is adjustable in 4 steps, from 0.5 to
2.5 mm.
– Use the cutting-length lever 2 on the underside of the appliance to set the
desired cutting length.
The attachment combs
– Figure D: switch off the trimmer and push the comb attachment 6 (4, 8, 12,
16, 20 mm) onto the cutter head 3.
– You can then cut hair with the trimmer as usual.
You can achieve the best cutting results in combination with a comb attach-
ment 6 when the cutting-length lever 2 is set to 1 (0.5 mm).
Charging state
The battery is almost empty.
The battery is partially charged.
The battery is full.
5 Cleaning and care
To ensure perfect functioning and full performance of your trimmer, clean and oil the
appliance regularly.
Cleaning and oiling the cutter head
If you use the appliance regularly, the cutter head 3 should be thoroughly
cleaned and oiled once a day.
– Switch off the appliance.
– Remove the comb attachment 6, if necessary.
– Remove any hair using the cleaning brush 4.
– Figure E: oil the areas where the bottom and top cutting blades touch.
Removing the cutter head
The cutter head 3 should additionally be removed at regular intervals, in order
to carefully remove residual hair particles from the interior using the cleaning
brush 4.
1. Ensure that the appliance is switched off (LED in On/Off switch 1 is not lit).
2. Removing: figure F: press on the top of the cutter head 3 with your thumb to
push it off the appliance.
3. Figure G: press the upper and lower blades apart slightly and use the cleaning
brush 4 to remove the hair from the gap.
4. Mounting: figure H: place the cutter head 3 on at the bottom and swing it
upwards until it clicks into place.
ENGLISH 21