Wiesenfield WIE-FMO-135S Manual De Instrucciones página 61

The driveline maximum allowable length must, when fully extended, have a mini
mum overlap of the profile tubes by not less than 1/3 the free length with both
inner and outer profile tubes being of equal length.
1. Apply multi-purpose grease to the inside of the outer shaft and reassemble the
driveline.
2. Assemble driveline profiles together with 1/3 overlapping of inner and outer
profile tubes. Once assembled, measure and record the maximum allowable
length shown below for future reference.
Driveline Maximum Extended Length (Figure 1-4)
3. Attach inner driveline yoke to the mower gearbox shaft. Attach outer driveline
yoke to the tractor's PTO shaft.
4. Move yoke ends of driveline back and forth to ensure they are secured to the
tractor and mower shafts. Reattach any end that is loose.
IMPORTANT: Small chains are supplied with the driveline. They must be attached
to the inner and outer driveline shields and to the mower and tractor to restrict
shield rotation.
5. Hook driveline safety chain on the tractor end of driveline to the tractor.
Relatch safety chain to the driveline shield.
6. Hook driveline safety chain on the mower end of driveline to the mower frame.
Relatch safety chain to the driveline shield.
7. Start tractor and raise mower just enough to remove blocks.