Publicidad
The apparatus should be cleaned as described in the section 13 titled MAINTENANCE, CLEANING,
DECONTAMINATION AND STORAGE, before, carry out the following:
1.
Close the cylinder valve by turning the cylinder valve handle clockwise until it reaches following its
end position.
2.
Thoroughly vent the system by pressing the purge button on the breathing valve.
3.
Disconnect the regulator(s) from the cylinder(s).
4.
Make sure the dust cover is firmly in place to keep water out of the first stage.
Carefully rinse the regulator with fresh, gently flowing water. Do not press the purge button.
5.
6.
Do not pull on the hoses when the regulator is still attached to the tank and, after removing the hoses,
avoid storing them on a tight loop.
7.
When the regulator is not connected, the cylinder valve must be fitted with a plug.
8.
Damp equipment should be thoroughly dried if it is to be stored in the backpack for more than a few
hours.
If you accidentally press the purge button during the rinsing procedures, then attach the
regulator to the tank and press the purge button for 10-15 seconds to purge any water or debris
from regulator.
DISMANTLING
NEPTUNE III Package Owner's Manual rel. 2.1
25
Publicidad
