infaco ELECTROCOUP F3015 Manual De Instrucciones página 60

THE SAFETY SYSTEM MUST ONLY BE CHECKED DURING CALIBRATION
(BEFORE TURNING IT ON).
THE UNIT MUST ALWAYS BE TURNED OFF AND THE BLADE CLOSED TO
AVOID THE RISK OF CUTS.
2. Press and hold the ON/OFF button on the
pruning shears until the LEDs come on. The
pruning shears are ready to use when the status pruning shears are ready to use when the status
LED fl ashes green.
- CALIBRATION
1. You can calibrate the DSES WIRELESS unit with or without a glove (see You can calibrate the DSES WIRELESS unit with or without a glove (see
section entitled, Using the Safety System)
- STARTING
1. If calibration has been done correctly, press the
trigger twice to start the pruner, work can then
begin. In the event of a fault, the pruning shears will begin. In the event of a fault, the pruning shears will
not turn on. Repeat the calibration steps carefully. If
the fault persists, refer to the Troubleshooting section
in the manual.
- CONNECTION
1. Using the socket locators, fi rst connect
the coiled cord to the battery and then to
the pruning shears. It is imperative to follow
the order of connection when powering on
the device.
work can then
11
1s
x2