infaco ELECTROCOUP F3015 Manual De Instrucciones página 64

TROUBLESHOOTING
INSUFFICIENT CONDUCTIVITY INDICATED DURING CALIBRATION (BARE
HAND OR GLOVE) : THE PRUNING SHEARS DO NOT START
- Not wearing the INFACO conductive glove
If an area of your un-gloved hand causes the ON/
OFF status LED to turn red, you must absolutely
wear an INFACO conductive glove to improve the
conductivity.
- Wearing 1 INFACO conductive glove
If an area of glove causes the ON/OFF status LED
to turn red, that zone is no longer functional:
- The glove may therefore be unusable and should be replaced.
- The glove may be dirty, it must be cleaned by hand using clean water
with no detergent and allowed to dry before repeating the calibration
steps.
- Wearing 2 INFACO conductive gloves
In order to determine which glove has insuffi cient conductivity, repeat the
calibration steps twice with one glove: fi rst remove one glove and then the other.
Refer to the paragraph "Wearing 1 INFACO cable glove".
Conductivity
level
Bar graph
ON/OFF
LED
15
Insuffi cient