Hella Micro-Xenon Instrucciones De Montaje página 9

When extending the cable set make
sure the cross section is large
enough.
Replacing the xenon bulb
Fig. page 3:
Unscrew housing 2 from the
headlamp.
Safety instructions
IMPORTANT!
The electrical connection between
headlamp and ballast carries high
voltage and must not be
disconnected.
Always switch off the headlamp
before changing the bulbs and
disconnect from the power supply.
Never insert foreign objects or
fingers into the plug.
9
The line resistance between ballast
and battery must not be greater
than 150 mOhm (for 12 V) or 300
mOhm (for 24 V).
Remove cover cap 11 .
Pull off plug 10 .
Unlatch and pull off adapter 3 for
illuminant.
Replace illuminant 5 and change
rubber seal 4 .
The ballast must never be operated
without a bulb, as dangerous
voltage spark-over, which leads to
damage, may occur at the plug.
Allow the bulb to cool off.
Wear safety goggles and gloves
when changing bulb.
The glass body of the xenon bulb is
filled with various gases and metal
gases under pressure (danger of
splintering).
Never touch the glass bulb of the
xenon lamp, touch the bulb at its
base only.
Use a clean cloth and alcohol to
remove any fingerprints from the
glass bulb.
Properly install and securely fasten
all cables.
Reconnect the earth cable to the
battery.
Reassemble and tighten headlamp
parts.
Dispose of used xenon bulbs as
hazardous waste.
Check function and adjustment of
the headlamps.
Only operate the bulb in a closed
headlamp.
A final tip:
Keep the cover lenses clean.
Dirt can absorb up to 80% of
the light output.
Do you carry reserve bulbs and
fuses in your car?
If you have any questions or
installation problems,: Contact
your Hella stockist.