Whirlpool WFC8090GX Manual De Uso Y Cuidado E Instrucciones De Instalación página 84

TROUBLESHOOTING
First try the solutions suggested here or please refer to the local service sheet that you will find
If you experience
Water Leaks (cont.)
Water or suds leaking from
door or rear of cabinet
Leaking around door
Wash Cycle Not Performing As Expected
Load not completely
covered in water
Washer/dryer won't run
or fill; washer/dryer stops
working
WARNING
Electrical Shock Hazard
Plug into a grounded 3 or 4 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Washer/dryer won't run
or fill; washer/dryer stops
working (cont.)
84
at the end of this manual for assistance and to possibly avoid a service call.
Possible Causes
Not using HE detergent or using
too much HE detergent.
Hair, lint, or other debris on inner
door window preventing proper seal
with rubber door seal.
Water level not visible on door
or does not cover clothes.
Check for proper water supply.
Check proper electrical supply.
Only use HE detergent. Suds from regular detergents
can cause leaking from the door or rear of cabinet. Always
measure detergent and follow manufacturer's directions based
on your load requirements.
Clean inner door window and seal. See "Cleaning the Door Seal"
in the "All-In-One Washer/Dryer Maintenance" section.
This is normal for the all-in-one washer/dryer. The washer/dryer
senses load sizes and adds the correct amount of water for
optimal cleaning.
Both hoses must be attached and have water flowing to the inlet
valves.
Water faucet must be turned on.
Check that inlet valve screens have not become clogged.
Check for any kinks in inlet hose, which can restrict water flow.
Plug power cord into a grounded 3 or 4 prong outlet.
Do not use an extension cord.
Ensure there is power to outlet.
Do not plug into a GFCI (Ground Fault Circuit Interrupter).
Check electrical source or call an electrician to check if voltage
is low.
Reset a tripped circuit breaker. Replace any blown fuses.
NOTE: If problems continue, contact an electrician.
Solution