Whirlpool WFC8090GX Manual De Uso Y Cuidado E Instrucciones De Instalación página 92

TROUBLESHOOTING
First try the solutions suggested here or please refer to the local service sheet that you will find
If you experience
Error Code Appears in Display (cont.)
Once any possible issues are corrected, touch the POWER button once to clear the code. Re-select and restart the cycle.
F5E4
Door not opened
between cycles
F6E1
Communication failure
between electronics
in washer/dryer
F6E2
Communication failure
between electronics
in washer/dryer
F8E1
No water flow detected/
fill timeout
F8E3
Overflow of water
detected/overflow cannot
drain
F9E1
Drain timeout/
drain pump failure
92
at the end of this manual for assistance and to possibly avoid a service call.
Possible Causes
Three consecutive cycles were run
without the door being opened. The
washer/dryer will generate an invalid
key beep when START is pressed.
Problem detected with the washer/
dryer electronics.
Problem detected with the washer/
dryer electronics.
Washer/dryer may not be connected
to the home water supply. Home
water supply valves may not be
turned on. Inlet hoses to washer/dryer
may be kinked. Inlet valves on
washer/dryer may have failed.
Inlet valves on washer/dryer are
leaking internally and washer/dryer
cannot drain during overflow.
Drain pump filter on washer/dryer
may need to be cleaned. Bellow
drain holes in washer/dryer may
be obstructed. Washer/dryer drain
hose or home drain system may be
obstructed. Drain pump on washer/
dryer may have failed.
Solution
Open and close the door. Check for obstructed door switch.
Verify functionality of door switch.
Try resetting the washer/dryer by unplugging it from the outlet
and then plugging it back in. If unsuccessful, call for service.
Try resetting the washer/dryer by unplugging it from the outlet
and then plugging it back in. If unsuccessful, call for service.
Make sure that the washer/dryer is connected to the home
cold water supply and that the home water supply valve is
turned on. Verify that the inlet hose to the washer/dryer is
not kinked. If problem persists, call for service.
Call for service.
Clean drain pump filter on washer/dryer. Check bellow drain
holes in washer/dryer for obstructions. Check washer/dryer
drain hose and home drain system for obstructions. If problem
persists, call for service.