Publicidad
Idiomas disponibles
Idiomas disponibles
STOP
TV PROG+/–
DBS RECEIVER BRAND NAME
JVC (DISH Network)
ECHOSTAR (DISH Network)
PRIMESTAR
RCA (DSS)
SKY
SONY (DSS)
Downloaded from:
https://www.usersmanualguide.com/
1
2
3
2
4
5
6
7
8
9
0
4
1
BRAND CODE
DBS Receiver Multi-Brand
Remote Control
The VCR's remote control can control functions on the brands
of DBS (Direct Broadcast Satellite) receiver listed below.
TURN ON THE DBS
ENTER
RECEIVER
1
Turn the power on using the DBS receiver's remote
NUMBER
control.
ENTER DBS RECEIVER
BRAND
2
While holding down CABLE/SAT on the VCR's remote
control, use the NUMBER keys to enter the DBS
receiver brand number from the chart in the left column
and then press STOP.
Follow the example shown below.
Check if the DBS receiver's power goes off as it should.
If it does, try other operations (
● Once you have set the remote control to operate the
OPERATE DBS RECEIVER
3
First, press CABLE/SAT to set the remote control to DBS
receiver mode, then press the corresponding button:
● Depending on the DBS receiver you may have to
● To change the DBS receiver's channel, press TV
NOTES:
● Depending on the type of DBS receiver, there may be cases
where some or all functions cannot be operated using the
remote control.
● It's not possible to operate a DBS receiver that is not
equipped with a remote control sensor.
● Though ECHOSTAR has a number of different remote codes,
this remote control is applicable only to one of those codes
preset at the factory.
● It's not possible to set the remote control for both your DBS
receiver and a cable box at the same time. You can only set
the remote control to operate one of these units at a time.
(Ex.) To set remote control to JVC 51:
51
CABLE/
SAT
51
50
40
52
Hold
down
41
DBS, you don't have to repeat this step until you
replace the remote control's batteries.
, TV PROG +/–, NUMBER keys.
press ENTER after having pressed the NUMBER keys.
PROG +/– or the NUMBER keys.
1
5
Press in succession
33
EN
step 3).
STOP
Release
Publicidad
