Publicidad
Step 9
Separate the EXTENSION SLIDES (35MC) from the EXTENSION RAILS (35MA) as
å
shown in the upper diagram below. Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (35MA) to the LEFT END/UPRIGHTS (B). Use four GOLD
å
5/16" FLAT HEAD SCREWS (3S) through holes #1 and #3.
NOTE: Use the exact holes shown in the ENDS (B).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged
å
diagram. Then, slide the inner cartridge of the EXTENSION RAIL in to fi nd the other hole
that lines up with the hole in the LEFT END/UPRIGHT. Turn a SCREW into this hole.
NOTE: The EXTENSION SLIDES (35MC) will be used later for the DRAWERS.
å
Push the black lever in and pull the SLIDE from the RAIL.
V
Open end
www.sauder.com/services
35MC
B
2
1
3S
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
35MA
B
3
424198
Open end
1
2
3
Page 13
Publicidad
