Publicidad
Idiomas disponibles
Idiomas disponibles
LED unit 170VS-RGB
Start up
First check that the lights are installed correctly
Manual sync of the RGB lights:
1. Activate the synchronization of the lamp programs by switching on the lights, check if all lights are on.
2. Switch off the power supply to the lamps and wait at least 20 seconds (max 60 seconds).
3. Switch on and off again (max 3 seconds on - max 3 seconds off).
4. Repeat once again: switch on and off (max 3 seconds on - max 3 seconds off).
5. Switch on the lights. Now all lamps are in the same program mode.
6. When the lights are synchronized they keep their setting until a light is replaced or switches off separately.
Changing the colour/program:
Change program by rapidly switching on and off the lights again. The lights shift to the next program (1–11, see below).
Memorizing the last color/program:
Select the desired colour/program. Turn the lights off, wait at least 20 seconds. The selected program is now stored.
Program
Name
1.
Candle light
2.
Warm white
3.
Neutral white
4.
Cold white
5.
Caribean blue
6.
Blue
7.
Green
8.
Red
9.
Purple
10.
Yellow dynamic
11.
Blue dynamic
Frost Risk
Always power off the lamps before a possible winter closure. For the lights not to freeze, we recommend the following:
1. Loosen the front ring.
2. Unclip the lightning element from the gasket.
3. Let the light gently fall to the bottom of the pool (hanging in the cable).
Troubleshooting
Problems
Solution
Lights indicate
Check that all lights are correctly connected to the same transformer and via the common power
different colour/
switch according to the schematics.
program
Carry out synchronization under "Manual sync" above.
Flickering light
• Switch on the lights. Select color Cold White (program number 4).
• Remove bulb from water. Loosen the nut and pull back the seal to access the brass connector inside
the connector (do not remove the connector).
• Measure the voltage at the bulb terminals (while the lamp is still on). The correct value should be at
least 10VAC 50/60Hz. If it is less: Check the voltage at the transformer. It should be between 12VAC
and 14VAC. Check that the transformer has adequate capacity to operate all connected lights.
If the transformer's voltage if fine, a thicker cable may be needed between the transformer and light.
Waste management and recycling
This product is disposed of in accordance with local laws and regulations. As this product contains electrical components, it must
be disposed of separately from household waste. When this product reaches the end of its life cycle, contact local authorities to
find out more about waste management and recycling.
Type
Colour
<2000K very warm white
Fixed
3000K warm white
Fixed
Fixed
5000K neutral white
Fixed
9500K cold white
cyan
Fixed
Fixed
blue
Fixed
green
red
Fixed
purple
Fixed
Slowly shifting
various yellow
Fast shifting
various blue
10
ENGLISH
Publicidad
