CTEK CHARGESTORM CONNECTED 2 Manual Del Usuario página 6

!
4. Attach the wall bracket to the desired wall
using the included three ST6.3 screws.
Locate two screw holes in the middle of the
5.
charging station, attach the station bracket
to it using the included push-clips and tighten
them using provided ST4 screws.
6. Position the charging station on the wall by
sliding the station bracket into the wall bracket.
7. Locate two screw holes at the top of the
charging station, insert the included spacers
from the outside, and fix the station to the wall
using the two included ST6.3 screws. Make
sure the rubber gaskets and washers are used
during the installation.
CAUTION: Do not install the charging station without
the rubber gaskets. Otherwise it can leak in water
and cause damage to the EV charger.
6
8. Make sure that the charging station is firmly
installed on the wall.
9. Make sure to cover all open holes with silicon or
rubber gaskets to protect the charging station
against water.
To install the charging station on a
wall without the mounting bracket
Drill four holes in the wall that align with the
1.
locations shown in the drilling template.
2. Unlock and open the technical box with the key.
3. Carefully remove the protection cover.
!
4. Install the charging station in the selected
location with the rubber gaskets first and then
the washer and the four ST6.3 screws.
CAUTION: Do not install the charging station without
the rubber gaskets. Otherwise it can leak in water
and cause damage to the EV charger.
5. Make sure that the charging station is firmly
installed on the wall.
6. Make sure to cover all open holes with silicon or
rubber gaskets to protect the charging station
against water.
User & installation instructions
To install the charging station on a
pole
• For installation on a pole, refer to the manual
for the pole mount kit.
To do the cable installation
1. Make sure that the power is off.
A 16 mm 2
A
2. Make sure that the cable installation is
dimensioned (A) for the charging station.
CAUTION: The cable glands must be replaced if the
cables are outside this specified range.
3. If the power cable and network cable should
be installed from below or from the back,
drill a hole using a step drill. Alternatively,
make a hole using the provided knockouts in
the backplate of the station, if available. It is
recommended to use additional sealant to
prevernt water instrusion.
CAUTION: Make sure not to damage
the components inside the unit when
drilling or making holes using knockouts.
Install the cable glands in the holes to protect
4.
the unit from dust and water penetration.
NOTE: The cable gland for the power cable that
is delivered with the product supports cable
dimensions between 11-17 mm and the gland for the
network cable supports cable dimensions 3-6 mm.
If the power cable and network cable are
5.
installed from the top, there are two holes on
the top of the unit. Install the power cable to
the larger hole (M25) and the network cable to
the smaller hole (M12).
CTEK AB