Amprobe WT-70 Manual De Uso página 12

Setup
The advanced setup mode lets you customize your meter.
7 parameters are available in this model.
P2.0: Memory Clear
P3.0: Electrode data (invalid for ORP probe)
P4.0: PH buffer selection (invalid for ORP probe)
P5.0: READY indication
P6.0: Temperature unit
P7.0: Real time clock
P8.0: Reset
To enter SETUP mode, hold down "SET"key >1 second while in normal
measurement mode. Press "" or ""to select parameters and press"ENTER"
for parameter settings. To exit any setting, press "Esc" key.
Note: P1.0 memory transmitting function is not available in this model.
P2.0: MEMORY CLEAR(CLr)
To clear the stored data, press "MODE" key to select mV unit before
entering setup mode. While in setup mode, press "" key to select
memory clear function P2.0, "CLr" icon appears on LCD.(Fig.5)
Press "ENTER" key to enter P2.1.The default " NO" icon flashes on LCD.
Press "" key to change and then press "ENTER" key to confirm.
NOTE: This procedure will clear 99 memories at a time. Please consider
carefully before delete.
Fig. 5
P3.0: ELECTRODE (ELE) – invalid for ORP probe
This function is invalid in WT-70 with ORP probe.
P4.0: PH BUFFER (buF) – invalid for ORP probe
This function is invalid in WT-70 with ORP probe.
6