Amprobe WT-70 Manual De Uso página 13

P5.0: READY indication (rdy)
Use this program to activate "READY" indication. "READY" icon appears
on LCD when the measured reading is stable. While in P5.0, press "ENTER"
to go into P5.1 and press "" or "" to switch Ready indicator ON or OFF
and then press "ENTER" to confirm. (Fig. 6)
Fig. 6
P6.0: TEMPERATURE UNIT (U)
Use this program to select the temperature unit. To display temperature,
extra temperature sensor (TPK-60) is needed. While in P6.0, press "ENTER"
to go into P6.1 and press "" or "" to switch C or F and then press
"ENTER" to confirm. (Fig. 7)
P7.0: REAL TIME CLOCK (rtc)
In P7.0, press "ENTER" to go through P7.1 to P7.6 for date and time settings.
Y-M-D and H:M:S will show in turn and corresponding digits will be flashing
for further change. Press "" to increase and "" to decrease the numbers
and press "ENTER"key to confirm every setting.
P8.0: Reset (rSt)
While in P8.0, press "ENTER"to go into P8.1. Select "n"-No or "y"-Yes with
""or "" for data reset to factory default. Press "ENTER"to confirm
selection.
Fig. 7
7