KRESS KC150 Manual De Instrucciones página 7

j) Do not put hands or feet near or under rotating
parts.
k) Always switch off the electric motor and remove
battery pack from the machine:
1) before clearing blockages;
2) before checking, cleaning or working on the
blade(s);
3) after striking a foreign object: inspect the blade(s)
for damage and make repairs before restarting and
operating the edger;
4) if edger starts to vibrate abnormally (check
immediately).
l) Always remove battery pack from the machine
whenever you leave the edger.
m) Always ensure that the ventilation openings are
kept clear of debris.
4. Maintenance and storage
a) Keep all nuts, bolts and screws tight to be sure the
equipment is in safe working conditions.
b) Replace worn or damaged parts.
c) Do not attempt to repair the machine unless you
are competent to do so.
d) Use only manufacturer-recommended replacement
parts and accessories.
e) When not in use, store the edger out of the reach
of children.
f) Inspect and maintain the edger regularly. Have the
edger repaired only by an authorized repairer.
SAFETY WARNINGS FOR
BATTERY PACK
a) Do not dismantle, open or shred cells or battery
pack.
b) Do not short-circuit a battery pack. Do not store
battery packs haphazardly in a box or drawer
where they may short-circuit each other or be
short-circuited by conductive materials. When
battery pack is not in use, keep it away from
other metal objects, like paper clips, coins,
keys, nails, screws or other small metal objects,
that can make a connection from one terminal
to another. Shorting the battery terminals
together may cause burns or a fire.
c) Do not expose battery pack to heat or fire.
Avoid storage in direct sunlight.
d) Do not subject battery pack to mechanical
shock.
e) In the event of battery leaking, do not allow
the liquid to come into contact with the skin
or eyes. If contact has been made, wash the
affected area with copious amounts of water
and seek medical advice.
f) Keep battery pack clean and dry.
g) Wipe the battery pack terminals with a clean
dry cloth if they become dirty.
h) Battery pack needs to be charged before use.
Always refer to this instruction and use the
correct charging procedure.
i) Do not maintain battery pack on charge when
not in use.
j) After extended periods of storage, it may
be necessary to charge and discharge the
battery pack several times to obtain maximum
performance.
k) Recharge only with the charger specified by
Kress. Do not use any charger other than
that specifically provided for use with the
equipment.
l) Do not use any battery pack which is not
designed for use with the equipment.
m) Keep battery pack out of the reach of children.
n) Retain the original product literature for future
reference.
o) Remove the battery from the equipment when
not in use.
p) Dispose of properly.
q) Do not use battery packs of different
manufacture, size or type.
r) Keep the battery away from microwaves and
high pressure.
SAVE THESE INSTRUCTIONS
USER MANUAL
REQUIREMENTS FOR
WIRELESS PRODUCT
a) Operation of this device is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and
(2) this device must accept any interference
received, including interference that may cause
undesired operation.
b) Caution: Changes or modifications to this unit
not expressly approved by the party responsible
for compliance could void the user's authority to
operate the equipment.
c) NOTE: This equipment generates, uses and
can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the
equipment and receiver.
- Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV
technician for help.
EN
7