Selecline 600107632 Manual De Utilización página 11

2.Undo the screws.Then remove the
hinge bracket.
2.Undo the screws.Then remove the
hinge bracket.
3. Prise up and lift off the top-left hinge cover. See Figure 5.
4. Move the hole cover from the left to the right side. Then lift off the door and place
it on a soft surface where it will not be scratched. See Figure 6.
5. Unscrew the bottom hinge and remove the adjustable feet from both sides. Then,
unscrew the hinge pin on the base of the appliance, turn the hinge bracket over
and thread the hinge pin through the hinge bracket and secure with the nut and
locking washer. See Figure 7.
6. Refit the hinge bracket with the hinge pin on the left side. See Figure 8. Reattach
the adjustable feet.
7. Replace the door. Ensure the door is aligned both horizontally and vertically. This
ensures the seals are closed on all sides before you tighten the top hinge.
8. Insert the top-left hinge bracket and secure into place with the two bolts. Make
sure to place the bolts in a diagonal formation as shown. See Figure 9.
8.
9.
10.
11.Put the hinge cover and the screw cover
back.
12. With the doors closed,check that the doors
are aligned horizontally and vertically and
that the seal is closed on all sides before finally
tightening the bottom hinge.Re-adjust the
levelling feet as needed.
11