MSW Motor Technics MSW-GP33-70 Manual De Instrucciones página 32

NOTE: after pumping water, if the pump sucks air, turn it off immediately
and pour cool water into the pump through the filler plug to cool it down.
3.3.2 STARTING THE ENGINE:
• Unscrew the fuel valve by moving the fuel valve lever to the open position
- "ON"
• (only if the engine is cold or stalls immediately after starting): Turn on the
suction, i.e., move the suction valve to the "ON" position (see suction
pictogram
• Move the ignition switch to the "ON" position.
• Grasp the starter jerk handle and slowly pull away from the unit until you
feel resistance, then pull with a firm motion, keeping the jerk handle in your
hand at all times even as it returns to the starting position. Repeat this
motion until the engine starts.
• Allow the engine to run at suction for about 1-3 minutes to reach operating
temperature.
Then smoothly turn off the suction (set its lever to "OFF" position) and set
the desired engine speed with the throttle lever - moving the lever in the
direction of the turtle pictogram decreases the speed, and in the direction
of
3.3.3 Turning the engine off
• Set the throttle lever to the lowest engine speed (pictogram of a turtle).
(see dispenser
in
the hare
pictogram in
the
pictogram
the above picture).
above
increases
image).
it.