Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Steps
Precautions
The installation methods listed in this manual are for reference only. Please purchase the required installation kit
yourself. For specific installation steps, please refer to the manual of the corresponding kit.
The installation tilt angle of the solar panel should be kept above 10°, otherwise dust accumulation and damage to
the performance of the module is likely. If the tilt angle is too small, please increase the frequency of cleaning the
solar panel.
During solar system installation, it is recommended to install solar panel with similar appearance and color
together.
The gap between two adjacent solar panels should not be less than 20mm. The minimum distance between the
frame of a single solar panel and the installation plane should be 40mm.
The maximum design load of the solar panel, as well as excessive forces due to thermal expansion of the support
structure, must be considered during system design. The specific system installation design is the responsibility of
the installation company.
Tilt Mount Bracket Installation
The system can flexibly regulate the elevation angle via adjusting the bracket to keep the solar panel at a vertical
angle to the sunlight. It can also be fixed on a flat level for a long time. It is recommended that you place the
modules horizontally during use to ensure the stability of the system.
Please use the tilt mount bracket kit for the installation. The kit includes the fixing bracket, adjusting bracket, and
attached bolts. If needed, please visit EcoFlow's official sales channel for the relevant purchase information.
How to Install
Fixing bracket
Package List
Drilled area
EN
Fixing bracket
Adjustable bracket
Glued area (gray)
5
Publicidad
