Klarstein DOLCE BACIO SMART Manual página 30

EN
30
OPERATION IN DETAIL
Plug the power plug into the mains socket. The backlight flashes. The
display shows [00] and flashes. Press the POWER button. The ice cream
mode is preset. At the same time, the symbol for ice cream mode flashes
1
(the symbols for the other modes also light up). The backlight of the
display lights up for 15 seconds and then goes out. In this case, press the
POWER button again to return to the power-on state.
Press the MENU button to enter one of the following modes: Ice Cream,
Cooling (only), Mixing (only), Yoghurt. The symbol of the selected mode
flashes (the symbols of the other modes also light up) and the standard
2
time for this mode flashes. If the backlight goes out within 15 seconds
without any other operation being performed, press and hold the MENU
button to return to mode selection.
Hardness setting mode in ice cream mode
In ice cream mode, the degree of hardness can be set manually. The time cannot
be adjusted in this mode.
Press the HARDNESS button to enter the hardness setting mode. The
1 degree of hardness increases with each press of the button. After the
start, the time display starts at [00:00].
If the hardness setting is interrupted unexpectedly, press the HARDNESS
button again to set the desired hardness level. As the ice cream has now
2
reached a certain degree of hardness, level 2 or level 3 must now be
selected.
Time setting mode in ice cream mode
In ice cream mode, the time can be set manually. The hardness cannot be adjusted
in this mode.
Press the TIME button to enter the time setting mode. Briefly press the
1
TIME button to increase the time in 1-minute steps. Press and hold the
time button to set the time faster up to 60 minutes.
While in ice cream mode, press the TIME button to adjust the ice cream
2
making time. The setting method is the same as described in point 1.