Schumacher Battery Extender SP1-CA Manual Del Usuario página 9

USING THE RING CONNECTORS
1. To permanently attach to a battery, loosen and remove each nut from
the bolt at the battery terminal.
2. Connect the red POSITIVE connector ring to the POSITIVE battery terminal.
3. Connect the black NEGATIVE connector ring to the NEGATIVE battery
terminal.
4. Replace and tighten the nuts to secure.
5. Connect the cable to the end of the charger output cord. Take care to
keep the wires and plug away from metal and moving parts.
6. Connect the charger to an electrical power outlet.
USING THE 12V ACCESSORY PLUG
1. Connect the end of the 12V accessory plug to the charger.
2. Insert the 12V accessory plug into the 12V accessory outlet.
3. Route the power cord from the charger through the vehicle's open window.
4. Connect the charger to an electrical power outlet.
BATTERY CHARGING TIMES
Ah = Amp Hour
BATTERY SIZE/RATING
SMALL BATTERIES
Motorcycle, garden tractor, ATV, etc.
Times are based on a 50% discharged battery and may change, depending on age
and condition of battery.
AUTOMATIC CHARGING MODE
When an automatic charge is performed, the charger switches to the
maintain mode (see below) automatically after the battery is charged.
ABORTED CHARGE
If charging cannot be completed normally, charging will abort. When charging
aborts, the charger's output is shut off and the CHARGING
orange) LED will flash. To reset after an aborted charge, unplug the charger
from the AC outlet, wait a few moments and plug it back in.
DESULFATION MODE
Desulfation could take 8 to 10 hours. If desulfation fails, charging will abort
and the CHARGING
COMPLETION OF CHARGE
Charge completion is indicated by the CHARGED
pulsing, the charger has switched to the maintain mode of operation.
(yellow/orange) LED will flash.
• 9 •
CHARGE TIME (2A)
6-12 Ah
12-32 Ah
(green) LED. When
2-3¾ h
3¾-10 h
(yellow/