Rupes RX153A Traduccion Del Manual De Instrucciones Originales página 7

WARNING: To reduce the risk of injury, user must read instruction manual
CE marking for EU market
Wear ear protection
Wear gloves
Disposal of decommissioned (WEEE Directive)
Arrow – act in the direction indicated by the arrow direction
TYPE
Ø Orbit [mm]
Ø Backing Pad [mm]
Backing Pad Thread
Holes Backing Pad
R.P.M.
Electronic speed control
Power (W)
Insulation Class
Weight [Kg] according to EPTA procedure
The values shown are based on a nominal voltage of 230V/50Hz. In case of voltages and frequencies of different power
values may vary. Refer to the label technical specifications to the values of the tool.
WARNING! Read all safety warnings, instructions, illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. Save all
warnings and instructions for future reference. The safety and accident prevention instructions are reported in the
"SAFETY INSTRUCTION" booklet which is an integral part of these documents. This operating instructions manual
indicates the additional information required for the specific use of the tool.
CORRECT USAGE
• This tool is designed to be used as a sander. Read all safety warnings, instructions, indications provided on
drawings and specifications provided with this tool. Failure to comply with all instructions provided below may
cause electrical shocks, fire and/or serious injuries.
• This tool is not intended to be used for metal brushing, polishing and cutting operations. The use of this tool
for unintended applications may cause hazards and injuries to people.
• The tool must be used with accessories that have been specifically designed or recommended by the
manufacturer. The fixing of the accessory to the tool does not guarantee a safe operation.
• The rated speed of the accessories must be at least equivalent to the maximum speed specified on the tool.
Using the accessories at speeds above the rated one, may cause them to break or be thrown into the air.
• The external diameter and thickness of the accessories must match the specifications of the tool. Accessories
with incorrect dimensions cannot be adequately protected or controlled.
• The configuration of accessories must match the tool. The use of accessories that cannot be perfectly fitted on
the tool may result in imbalance, excessive vibrations and in the impossibility of controlling the tool.
• Do not use damaged accessories. Before use, inspect all the accessories. Inspect the supporting pads and
verify there are no cracks, tears or excessive wear. If the tool or accessory has fallen, verify that it is not
damaged or install a new accessory. After inspecting or installing an accessory, test the operation of the
tool at maximum speed and without load for one minute, keeping at a safety distance. If the accessories are
damaged, they will break during this test.
Summary of device labels containing safety information
TECHNICAL SPECIFICATIONS
Eurasian conformity mark
Wear eye protection
Wear a mask
RX153A/RX253A
3
150
5/16"
MULTIHOLE
4.000÷10.000
•
250
I
1,2
ENGLISH
RX156A/RX256A
6
150
5/16"
MULTIHOLE
4.000÷10.000
•
250
I
1,2
7