SYMBOLS
To reduce the risk of injury, user must read
instruction manual
Warning
Wear ear protection
Wear ear protection
Wear dust mask
For indoor use only
Do not expose to rain or water
Do not burn
Fuse
Double insulation
Positive terminal
Negative terminal
Do not dispose of batteries, Return exhausted
batteries to your local collection or recycling
point.
EN
OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The machine is intended for driving in and loosening screws
as well as for drilling in wood, metal and plastic.
BEFORE PUTTING INTO OPERATION
1. CHARGING THE BATTERY PACK (SEE FIG.
A)
NOTE:
a)
Do not use any charger other than that specifically
provided for use with the equipment.
b)
If the battery pack is very hot you must remove your
battery pack from the charger and allow time for the
battery to cool down before recharging.
c)
The battery in your new tool is not charged when it
leaves the plant. Therefore it must be full charged
before using the first time
d)
Please charge the battery to reach full or no less than
half charge before storage. If the tool will not be used
for long periods of time, charge the battery every 3-6
months
1)
Plug the charger into an appropriate outlet. The light
will be green.
2
Place the battery pack into the charger, the light
will turn to red to indicate the charging process has
started.
3)
When charging is completed, the light will turn to
green. The pack is now fully charged, unplug the
charger and remove the battery pack.
NOTE: If the battery pack is locked in the
charger, press the battery pack release
button and remove it.
WARNING: When battery charge runs
out after continuous use or exposure to
direct sunlight or heat, allow time for the
battery to cool down before re-charging to
achieve the full charge.
CHARGING INDICATOR
This charger is designed to detect some problems that can
arise with battery packs. Indicator lights indicate problems
(see table below). If this occurs, insert a new battery
pack to determine if the charger is OK. If the new battery
charges correctly, then the original pack is defective and
should be returned to a service center or recycling service
center. If the new battery pack displays the same problem
as the original Battery Pack, have the charger tested at an
17