Levoit VeSync Core 600S Serie Manual Del Usuario página 19

CARE & MAINTENANCE (CONT.)
When Should I Replace the
Filter?
The filter should be replaced every 6–12
months. You may need to replace your filter
earlier or later depending on how often you
use your air purifier. Using your air purifier in
an environment with relatively high pollution
may mean you will need to replace the filter
more often, even if
You may need to replace your filter if
you notice:
• Increased noise when the air
purifier is on
• Decreased airflow
• Unusual odours
• A visibly clogged filter
Note:
•
To maintain the performance of your air
purifier, only use official Levoit filters. To
buy replacement filters, go to Amazon
and search [ASIN].
•
Remember to reset
the filter (see page 18).
Cleaning the AirSight Plus
Laser Dust Sensor
The AirSight Plus Laser Dust Sensor can be
blocked by dust, which affects the sensor's
accuracy. Clean the sensor every 3 months.
Using your air purifier in an environment with
more dust may mean you will need to clean
the sensor more often.
1. Unplug the air purifier.
2. Place the end of a vacuum cleaner over
the sensor openings. [Figure 3.2]
3. Turn the vacuum on for at least 10
seconds to clean out dust.
is off.
after changing
Replacing the Filter
1. Unplug the air purifier. Flip the air purifier
over or turn it on its side. Remove the filter
cover (see Getting Started, page 9).
2. Remove the old filter.
3. Clean out any remaining dust or hair inside
the air purifier using a vacuum hose.
Note: If you remove and set aside the top
half of the air purifier, you can use water to
clean the bottom half of the air purifier.
Do not use water or liquids to clean the top
half of the air purifier. [Figure 3.3]
4. Unwrap the new filter and place it into the
housing (see Getting Started, page 9).
5. Replace the cover. Plug in the air purifier.
6. Reset the Check Filter Indicator
(see page 18).
Storage
If not using the air purifier for an extended
period of time, wrap both the air purifier and
the filter in plastic packaging and store in a
dry place to avoid moisture damage.
Figure 3.2
Figure 3.3
EN
19