KRESS KC100 Manual De Instrucciones página 9

Batteries may enter water
cycle if disposed improperly,
which can be hazardous for
ecosystem. Do not dispose of
waste batteries as unsorted
municipal waste.
Make sure the battery is
removed prior to changing
accessories.
Trimming
ASSEMBLY & OPERATION
NOTE: Before using the tool, read the
instruction book carefully.
BEFORE OPERATION:
Assembling the cutting head (See Fig. A1)
Fit the cutting head. Insert the hex key into the hole
and rotate the trimmer head counterclockwise until it
stops in a locked position.
A1
Assembling the debris guard (See Fig. A2)
A2
1. Install the correct Debris Guard for the trimmer
head.
2. Secure the guard in place using the screw and
torx key.
Assembling the Front Handle (See Fig. B)
B
1. Attach the Front Handle and lower clamp on the
shaft.
2. Put the bolt through the holes.
3. Tighten the Front Handle.
WARNING: Adjust the Front Handle as
desired so as to make sure your front arm is
straight when using the trimmer.
Fitting the shoulder strap (Sold Seperately)
(See Fig. C)
1. Adjust the length of shoulder strap to make sure
that the carabiner is about a hand's width below
the top of your hip.
2. Connect the carabiner of the accessory shoulder
strap to the mounting point on the shaft of the
trimmer.
C
Installing & removing the battery pack
(See Fig. D1, D2)
1. Slide the battery pack into the battery
compartment until you hear a click.
2. Press the battery pack release to release battery
pack from your tool.
EN
9