KRESS KG154E Manual De Instrucciones página 14

MAINTENANCE
Always remove the battery pack from your trimmer after use.
Always check the product prior to being used for any damage.
After use, disconnect the battery from the tool and check for damage.
Your power tool requires no additional lubrication or maintenance. There are no user serviceable parts in
your power tool. Never use water or chemical cleaners to clean your power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry room temperature location. Keep the motor ventilation slots clean. Keep
all working controls free of dust.
TROUBLESHOOTING
The following table gives problems and actions that you can perform if your machine does not operate
correctly.
Warning: Switch the machine off and remove the battery prior to any troubleshooting
Problems
Trimmer fails to operate
14
Trimmer runs intermittently
EN
Excessive vibrations/noise.
Cutting time per battery charge
too short.
Machine does not cut
Continuous lighting of the battery
charge indicator.
No charging procedure possible.
Battery charge indicator does not
light up
.
Possible Causes
Battery discharged.
Battery too hot/cold.
Motor is broken.
.
Internal wiring of machine
damaged
.
Motor is broken.
Battery not fully charged.
.
On/Off switch defective.
Machine defective.
Line spool is not wound well.
Battery has not been used for long
period or only charged for short term.
Grass too high.
Battery defective.
Line broken.
Battery not fully charged.
Motor is broken (speed is too low).
Grass entangled around cutting
head
Battery not (properly) inserted.
Battery contacts contaminated.
Battery defective.
Plug of battery charger not
plugged in (properly).
Socket outlet, mains cable or
battery charger defective.
Corrective Action
Recharge battery; also see
the content in charger manual.
Allow to cool/warm.
Contact Service Agent.
Contact Service Agent.
Contact Service Agent.
Recharge battery.
Contact Service Agent.
Contact Service Agent.
Rewind the line. See '' To fit spool
and line assembly.'
'
Fully charge battery; also see the
content in charger manual.
Cut in stages.
Replace the battery.
Replace the line.
Recharge battery; also see the
content in charger manual.
Contact Service Agent.
Remove grass.
Properly insert battery into battery
charger.
Clean the battery contacts or replace
the battery.
Replace the battery.
Insert mains plug (fully) into the
socket outlet.
Check the mains voltage; have
the battery charger checked by
an authorized after-sales service
agent.