Publicidad
Idiomas disponibles
Idiomas disponibles
–
Launching a recipe
–
Out of beans detection: light alert (W),
–
Fill the coffee bean container with coffee beans
–
Press "START/STOP"
–
Restarts the recipe, to avoid wasting coffee.
Caution: The use of oily coffee can lead to erroneous detection due to poor bean throughput. If detection
activates, simply press the START/STOP button again to continue the recipe.
The function can be manually disabled (see "OTHER FUNCTIONS" - "Disable the beans missing function").
ANSWERS TO YOUR QUESTIONS
PROBLEM
The machine displays a fault, the
software is frozen.
OR
Your machine has a malfunction.
The appliance does not turn
on after pressing the ON/OFF
button (for at least 3 seconds).
A power failure has occurred
during a cycle.
The grinder stops during recipe
with beans LED lit.
Grinder turns empty.
The grinder makes an abnormal
noise.
There is water under the device.
The adjustment button for the
grinding fineness is difficult to
turn.
The device has not issued any
coffee.
You have used ground coffee
instead of coffee beans.
Water runs from the coffee
nozzles when the machine stops.
28
alert + grinder stops
CORRECTIVE ACTIONS
Turn off and unplug the machine, remove the filter cartridge, wait 1
minute and restart the machine.
Press and hold the ON/OFF button for at least 3 seconds for starting.
Check the fuses and the power socket of your electrical installation.
Check that the two power plugs are correctly inserted into the socket.
The appliance resets automatically when it turns back on.
Add beans and press start again.
Machine self-learning.
Foreign bodies are surely present in the grinder.
Before removing the water tank, wait 15 seconds after the flow of
coffee so that the machine finishes its cycle correctly.
Verify that the drip tray is well positioned on the machine. It must
always be in place even when the machine is not in use.
Verify that the drip tray is not full.
Turn the adjustment button of the grinding fineness only when the
grinder is operating.
An incident has been detected during its making.
The device is reset automatically and is ready for a new cycle.
Use your vacuum cleaner to collect the ground coffee contained in
the bean container.
Automatic rinsing to clean the coffee nozzles and prevent clogging.
PROBLEM
The milk frothing accessory
Check that the milk frothing accessory is correctly positioned on its
makes a noise.
non-removable attachment fixed to the machine (G3).
The milk frothing accessory on
Make sure that your milk frothing accessory is not blocked by milk or
your machine seems partly/
chalky residues. Unclog the holes with the needle supplied with your
completely blocked
appliance. See chapter 6 - CLEANING THE MILK FROTHING ACCESSORY,
OR if the milky recipe or hot
figs 1 to 8.
water stops prematurely and the
front panel alert flashes.
The milk frothing accessory does
For milk-based preparations, we advise you to use fresh, pasteurised
not or does not make much milk
or UHT milk, recently opened. We also recommend using a cold
froth.
container.
Nothing comes out of the milk
a. When frothing milk for the first time, if nothing comes out correctly.
frothing accessory.
• Check that the milk frothing accessory is not blocked. See
above: "The accessory of your machine appears to be partially or
completely blocked.
• Perform the following protocol once only:
• Empty the water tank and temporarily remove the Claris Aqua Filter
System cartridge. Fill the tank with mineral water high in calcium
(>100mg/L) and make successive steam cycles (5 to 10 cycles) in
a container until a continuous jet of steam is obtained. Put the
cartridge back in the tank.
b. The milk frothing accessory had previously worked:
• Ensure that the accessory output is not blocked. See above: "The
outlet of your machine's milk frothing accessory appears to be
partially or completely blocked".
If after completing the above steps it still does not work, please
contact your service centre.
Water or steam comes out of the
Check that the milk frothing accessory is correctly positioned on
milk frothing attachment.
its non-removable attachment fixed to the machine (G3). At the
beginning or end of the recipe, a few drops may flow through the
accessory.
Appearance of steam under the
Close the cleaning tablet funnel located under the lid. (J)
bean tray lid.
The machine does not request
The descaling cycle is requested from a large number of uses of the
descaling.
steam circuit.
Some grounds are in the drip
A small amount of ground coffee can get into the drip tray. The
tray.
machine is designed to evacuate any excess ground coffee so that the
percolation zone remains clean.
The light alerts are still lit up after
Reinstall the coffee grounds collector.
you have emptied the coffee
grounds tray.
After filling the water tank, the
Check the correct positioning of the tank in the device.
light alerts remain on.
The floats at the bottom of the tank must move freely. Check and
unlock the floats if necessary.
CORRECTIVE ACTIONS
29
Publicidad
