Descargar Imprimir esta página

Emerio SI-123563.1 Manual De Instrucciones página 6

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 50
SI-123563.1
PARTS IDENTIFICATION
1.
Temperature regulator
2.
Burst of steam button
3.
Spray button
4.
Spray nozzle
5.
Water inlet cover
6.
Indicator light
7.
Steam control knob
8.
Soleplate
9.
2-position switch
10. Water tank
11. Power light on the stand
12. Power stand
Note: To change the steam setting, switch the steam control knob to below positions.
"0" means "steam off"; "
To use the self-cleaning, switch and hold the steam control knob to the rightmost position.
BEFORE INITIAL USAGE
Remove all packaging material. Make sure the appliance is unplugged and the temperature regulator is set at
position "MIN".
Open the water inlet cover and fill water into the opening up to the max level marked on the water tank. For
this, use the measuring cup. Do not use chemically de-calcified water.
Insert the power plug into a designated outlet and set the temperature regulator on the highest temperature
setting. After the indicator light goes off, press the steam control knob to select your desired steam setting and
iron on an old piece of cloth to remove possible residue.
With first use, there can be slight odour or smoke, but this is harmless and only of short duration. Make sure
there is adequate ventilation.
OPERATION
Before selecting the temperature, read the instruction manual for the iron or the care advice on the tag of the
clothing.
Note: If there is no care advice on the piece of clothing, then you should begin ironing with the lowest
temperature. With lower temperature, there will be less steam.
MIN
●●
●●● MAX
2-position switch on the stand:
- cordless mode: flip the switch to this unlock position, the appliance can be used without the stand. Note
that always replace the iron on the stand during ironing intervals.
- corded mode and storage position: flip the switch to this locked position, the iron and the stand would be
locked together. Note that the bottom of the iron should be first aligned with the center of the power stand,
" means "low output of steam"; "
Nylon
Silk, wool
Linen, cotton, the highest temperature
" means "high output of steam".
- 5 -
EN

Publicidad

loading