Emerio SI-123563.1 Manual De Instrucciones página 7

otherwise the locking may be failed.
When use in cordless mode, first connect the iron to the power for about 30 seconds. There are three kinds of
conditions and time for reference:
For burst of steam function, it can work for about 1 minute.
For steam ironing, it can work for about 1.5 minute.
For dry ironing only, it can work for about 2 minutes.
Note: If you wish to apply numerous shots of the steam, you'd better use the iron in the corded mode.
DRY IRONING

Connect the iron to a suitable mains supply outlet.

Ensure that the steam setting is in the position "

Select the setting on the temperature regulator.

When the indicator light goes off, the required temperature is reached. The iron is ready for use.

To turn off the iron, turn the temperature regulator counter-clockwise to position "MIN", set the iron
upright, and pull out the power plug.
STEAM IRON
Fill the water tank, as described before initial usage.
Steam ironing can be used in the temperature ranges ●, ●●, ●●● MAX. For the reliable functioning of the
steam ironing, the water tank must be at least 1/4 filled.
Spraying function: Press the spray button to moisten a spot to be ironed. Water will come out of the spray
nozzle.
Steam Function: Press the steam control knob to select your desired steam setting, after preheating the steam
iron first, steam starts coming out from the holes in the soleplate.
Burst of steam: Turn the temperature regulator to the position "MAX". The indicator light will go off when the
required temperature is reached. Then press the burst of steam button. This function provides an extra amount
of steam to remove stubborn wrinkles. For optimal use, please allow the appliance to have a rest of 3 - 5
seconds between each press.
"Burst of steam" can also be applied when holding the iron in vertical position, which is useful for removing
creases from hanging clothes, curtains, etc.
The iron surface must always be kept in an upright position.
To turn off, turn the temperature regulator counter-clockwise to "MIN" and pull out the power plug.
Turn the appliance upside down and carefully pour the remaining water out of the water tank. Carefully shake
the appliance.
Press the spray button to allow possible remaining water to come out more easily.
ANTI-DRIP FUNCTION
The appliance has an anti-drip system, designed to prevent water escaping from the soleplate when the iron is
too cold.
Note: During use, the anti-drip system may emit a loud clicking sound particularly when heating up or cooling
down. This is perfectly normal and indicates that the system is functioning correctly.
SELF-CLEAN FUNCTION
You can use the self-clean function to remove scale and impurities.
The self-clean function should be used at least once per month.
If the water is very hard in your area, use the self-clean function every two weeks.
0
".
- 6 -