AYR 752 Manual De Instrucciones página 12

2. Installation
• 1. Replace the existing door viewer or drill a 14mm hole in the door
at eye level. Insert the camera from the outside while inserting the
washer between theback ofthe lens and the door. Make sure that the
arrow mark onfront of the camera points upwards.
• 2. Fit the holding plate over the end of the lens then screw the
locking barrel on to the threaded part of the camera and tighten(a
tightening tool is provided), this will hold the plate to the door.Make
sure that the arrow on the plate points upwards.
12