Tabletop Countdown Timer Instructions
1. Time Set Button: Press this button to select the desired countdown time.
2. LCD Display: When setting the timer, the display will show the selected time.
During count down, the display will show remaining time until off.
3. Power Indicator light:
On: Timer is plugged in but power is off to lamp / device.
Off: Lamp / Device is powered on and timer is counting down.
4. Time Set Locking Switch: When switch is set to "open"
button can be used to set/reset the timer. When set to "lock" the timer
cannot be set/reset. Previously set program will continue to run when set to
"lock" .
Setting the Timer
With each button, pressing the countdown time will increase and will display
as Minutes (1, 2, 5, 10, 15, 30), or Hours (1H to 9H). If button is pressed
after 9H is selected, the display will show 00, and power to the light/device
will be turned off. To set the countdown time, press the button until the
desired time is shown on the display. The time will flash 3 times, indicating
the time has been selected, and the LED will turn off, and the powered
device will turn on.
Count Down (Timer) Mode
During countdown, the display will show the above values in descending
order. 9H will be displayed if the time left is between 9 hours and 8 hours.
After 1 hour has passed, the timer will read 8H. This will continue on
throughout the countdown cycle, with the display reading the last hour
setting that has passed. When below 1 hour of the time remaining, the
display will read the actual number of minutes left. The display will continue
to count down with 01 showing for the last minute before the light/device
turns off. After light/device is off, the display will show 00. During
countdown, the display will blink of and on every few seconds to indicate
that the timer is functioning correctly.
1 Year Limited Warranty
AmerTac warrants to the original purchaser that this product will be free from defects in materials and workmanship for a period of 1 year from the date of purchase.
Additional details are available at www.amertac.com. PROP. 65 WARNING: This product contains chemicals known to the State of California to cause cancer, birth
defects or other reproductive harm.
Questions, ¿Preguntas?, Questions? 201-661-9945
©2013 AmerTac™
250 Boulder Drive
Breinigsville, PA 18031
www.amertac.com
Made in China/Fabriqué en Chine/ Hecho en China
I13-0005-A
the timer set
Caution:
Do not use timer with load that exceeds timer ratings.
Specifications:
125V~, 60Hz
625W (5A) Tungsten
1000W (8A) Resistive
TM26
LCD Display
Écran ACL
Pantalla LCD
Time Set Button
Bouton de réglage de la durée
Botón de ajuste del tiempo
Power Indicator Light
Voyant d'alimentation
Luz indicadora de potencia
Fiche technique :
Especificaciones:
125 V~, 60 Hz
125 V~, 60 Hz
625 W (5 A) tungstène
625 W (5 A) tungsteno
1000 W (8 A) résistifs
1000 W (8 A) resistivos