Hagen FL Venezia 190 Manual De Instrucciones página 27

4. Replace the impeller in the well:
a. Align the shaft so it is seated in the ring on the cover and press the cover into place.
b. Slide the tabs outward until they "click" to indicate the cover is locked in position.
Models 105 and 205 only:
WARNING: The yellow ceramic impeller shaft is permanently attached
to the plastic holder and is brittle to lateral pressure. Take extreme care
when handling the impeller.
Do not remove the ceramic shaft assembly unless it breaks.
If you need to remove it, insert the ceramic shaft tool until you feel it
engage at the base of the shaft, then pull up gently.
To replace it, position a new magnetic impeller on the assembly and
insert into the impeller well. Push on the impeller fan until the assembly
locks into place.
Replace foam screen in canister. (Insert with flat end down.)
Models 305 and 405 only:
WARNING: The ceramic impeller shaft is fragile. Take extreme care when
handling it. The shaft is held at the bottom of the impeller well by a
rubber support. The shaft can be extracted easily and reinserted by
hand; however, pay close attention to be certain the rubber support does
not become unseated. (Always replace the impeller cover to ensure
proper alignment).
The Impeller will wear out over time. A replacement may be ordered from your local Fluval dealer or by
contacting Customer Service at Rolf C. Hagen (UK) Ltd. or Rolf C. Hagen Inc. in Canada.
REPLACEMENT PARTS
Order replacement part from your Fluval dealer or by contacting Customer Service.
A Rubber Feet
B MSF Motor Housing
C Foam Screen Frame
D Media Basket
E Media Basket Tray
F Media Basket Cover
G Gasket
I Aquastop Valve
P Ribbed Hosing
Q Hose-Lock Nuts
T Instant-Prime Assembly
U MSF Filter Canister
V1 Ceramic Shaft Assembly
V2 Ceramic Shaft & Rubber Support
W Magnetic Impeller
X Impeller Cover
Y Impeller Well Insert
Z Ceramic Shaft Tool
Z Metal Clamp
2
205 305 405
A-20121 A-20121 A-20121
A-20185 A-20190 A-20195
A-20137 A-20137 A-20177
A-20045 A-20070 A-20070
A-20047 — —
A-20042 A-20067 A-20067
A-20038 A-20063 A-20063
A-20060 A-20060 A-20060
A-20012 A-20012 A-20012
A-20058 A-20058 A-20058
A-20020 A-20020 A-20020
A-20187 A-20192 A-20197
A-20041 — —
— A-20066 A-20066
A-20111 A-20152 A-20172
A-20136 A-20156 A-20156
— A-20174 A-20174
A-17015 — —
A-20013 A-20013 A-20013
30
4. STRIP-LIGHT CANOPY MAINTENANCE
WARNING: Fluorescent tubes are made of glass. Handle Strip-Lights and tubes with care.
RECOMMENDATION: Use only standard aquarium normal output fluorescent bulbs as per the
wattage rating indicated on the electrical data label located on the Strip-Light. Always use
original spare parts only.
REPLACING THE FLUORESCENT TUBE(S) OF THE STRIP-LIGHT
1. Disconnect the Strip-Light from power supply.
WARNING: Be sure you unplug the power cord. Switching off the
lights with the line cord switch or the Light Timer is NOT enough.
31