Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALL WEATHER STRIPPING
(ONLY APPLICABLE TO ENERGY STAR
MODELS)
In order to minimize air leaks between the air
conditioner and the window opening, trim the
weather stripping (e) to the proper length, peel
off the protective backing and plug any gaps if
needed (See Figure 21).
IF AC IS BLOCKED BY STORM
WINDOW
If a storm window prevents the air conditioner
cannot be removed, use a board with a
width of at least 1-1/2" and a thickness that
allows clearance for the installation of the unit
(Figure 22) . Be sure the drain holes or slots
for the storm window frame are not caulked
or painted shut. Rain water or condensation
must be allowed to drain out.
REMOVING AC FROM WINDOW
Turn the unit off and disconnect power cord. Remove sash seal from between windows, and unscrew
safety sash lock. Remove all screws installed through frame and frame lock. Remove the R1 Panel and
carefully not to spill any remaining water while lifting unit from window. Store parts with air conditioner. It is
recommended to have two people to remove the air conditioner from the window.
Storm window
frame or other
obstruction
1-1/2" (38 mm)
minimum
, raise sash and carefully remove. Be
18
Figure 21
Figure 22
Sash
Board thickness
as required, for
proper pitch to
rear, along entire
sill. Fasten with
nails or screws.
Publicidad
