Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
OPERATION OF CURRENT DEVICE
The power supply cord contains a current device that senses damage to the power cord. To test your
power supply cord do the following:
1.
Plug in the Air Conditioner.
2.
The power supply cord will have TWO buttons on the plug head. Press the TEST button, you will
notice a click as the RESET button pops out.
3.
Press the RESET button, again you will notice a click as the button engages.
4.
The power supply cord is now supplying electricity to the unit. (On some products this it also
indicated by a light on the plug head.)
NOTE: DO NOT use this device to turn the unit on or off.
NOTE: ALWAYS make sure the RESET button is pushed in for correct operation.
NOTE: The power supply must be replaced if it fails reset when either the TEST button is pushed, or it
cannot be reset. A new one can be obtained from the product manufacturer.
NOTE: If power supply cord is damaged, it cannot be repaired. It MUST be replaced by one obtained
from the product manufacturer.
Before you begin, thoroughly familiarize yourself with the control panel as shown below and all its
functions then follow the symbol for the functions you desire. The unit can be controlled by the unit control
alone or with the remote.
NOTE: All illustrations in this manual are for explanation purpose only. Your air conditioner may be
slightly different.
CONTROL PANEL
TO TURN UNIT ON OR OFF
Press the
(ON/OFF) button to turn the unit on or off.
NOTE: The unit will automatically initiate the Energy Saver
function under Cool, Dry, Auto modes (only when set to Auto-
Cooling and Auto-Fan).
TO CHANGE TEMPERATURE SETTING
Press
/
(UP/DOWN) button to change temperature setting.
NOTE: Press or hold either UP (
button until the desired temperature is seen on the display. This
temperature will be automatically maintained anywhere between
62°F (17°C) and 86°F (30°C). If you want the display to read the
actual room temperature, see To Operate on Fan Only section.
TO ADJUST FAN SPEEDS
Press
(FAN) button to select the Fan Speed in four steps-Auto,
Low, Med or High. Each time the button is pressed, the fan speed
mode changes. On Dry mode, the fan speed is controlled at Low
automatically.
) or DOWN (
)
19
Figure 23
TEMP/TIMER
On
Off
Timer
Sleep
Check
Filter
Auto
Auto
Low
Cool
Med
Dry
High
Fan
Mode
Fan
Energy
Saver
Publicidad
