Descargar Imprimir esta página

NORPOLE NPRAC6KEWMZ1 Manual Del Usuario página 26

Aire acondicionado de ventana 6000 / 8000 / 10000 / 12000 btu

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING
Please check the following before calling for service.
Problem
Air conditioner does not
start.
Air from unit does not
feel cold enough.
Air conditioner cooling,
but room is too warm.
Ice forming on cooling
coil behind decorative
front.
Air conditioner cooling,
but room is too warm.
NO ice forming on
cooling coil behind
decorative front.
Air conditioner turns on
and off rapidly.
Noise when unit is
cooling.
Water dripping INSIDE
when unit is cooling.
Water dripping
OUTSIDE when unit is
cooling.
House fuse blown or circuit breaker tripped. Replace fuse with time delay type or reset
circuit breaker.
Plug Current Device Tripped. Press the RESET button.
Power is OFF. Turn power ON.
Room temperature below 62°F (17°C). Cooling may not occur until room temperature
rises above 62°F (17°C).
coil.
Set to a Lower temperature.
Compressor stopped when changing modes. Wait for 3 minutes after set to the COOL
mode.
Outdoor temperature below 64°F (18°C). To defrost the coil, set FAN ONLY mode.
FAN ONLY mode.
Thermostat set too cold for night-time cooling. To defrost the coil, set to FAN ONLY
mode. Then, set temperature to a higher setting.
Temperature is set too High, set temperature to a Lower setting.
Air directional louvers positioned improperly. Position louvers for better air distribution.
Front of unit is blocked by drapes, blinds, furniture, etc. restricting air distribution. Clear
blockage in front of unit.
Doors, windows, registers, etc. open allowing cold air to escape. Close doors, windows,
registers, etc.
Unit recently turned on in hot room. Allow additional time to remove stored heat from
Outside temperature extremely hot. Set FAN speed to a higher setting to bring air past
cooling coils more frequently.
Air movement sound. This is normal. If too loud, set to a slower FAN setting.
Window vibration from improper installation. Refer to installation instructions or check
with installer.
Improper installation. Tilt air conditioner slightly to the outside to allow water drainage.
Refer to installation instructions - check with installer.
Unit removing large quantity of moisture from humid room. This is normal during
excessively humid days.
Solution
26

Publicidad

loading

Este manual también es adecuado para:

Nprac8kewmz1Nprac10kewmz1Nprac12kewmz1