Publicidad
OPERATING INSTRUCTIONS
8. LED Work Light
The LED work light (F), located on the base of
the impact driver, will illuminate when the trigger
switch is depressed. This provides additional light
on the surface of the work piece for operation in
lower-light areas.
The LED work light will turn off after approximately
10 seconds after the variable-speed trigger switch
is released.
• The LED work light will flash rapidly if the
tool has stopped automatically when the tool
became overloaded or too hot. Please wait for
the tool to cool down, at which point it can be
started again.
• The LED work light will flash slowly to indicate that the battery charge is very low. Please
recharge the battery pack.
9. Installing and Removing a Bit
NOTICE: Use only bits with power grooves. Do not
use a bit that has a damaged shank.
This tool is equipped with a one-hand quick clip
sleeve that allows you to quickly install the bit.
To install the bit:
a. Place the direction-of-rotation selector (B) in
the center (lock) position.
b. With one hand, hold the tool. With the other
hand, insert a 1/4 in. (6.35mm) bit into the
hexagonal hole in the quick-change collet. The
bit will be secured automatically.
c. Make sure the bit has been secured properly before any operation.
To remove the bit (Fig. 9):
a. Place the direction-of-rotation selector (B) in the center (lock) position.
b. With one hand, pull the sleeve of the quick-change collet (A) away from the tool and hold it
in place.
c. With the other hand, remove the bit from the quick-change collet.
d. Release the sleeve and check that it returns to its original position.
WARNING
• Use protective gloves when removing the bit from the tool, or first allow the bit to cool. The
bit may be hot after prolonged use.
8
9
A
14
F
Publicidad
