Descargar Imprimir esta página

AYR 754 Manual De Usuario página 13

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

2. Installation instructions
Replace the existing door viewer or drill a 14mm hole in the door at the
1.
required height. Peel off the 3M sticker top layer and then insert the ca-
mera from the outside . Ensure the door bell button is under the camera
and adjust the camera vertically to the ground(FIG.1)
Warning: It is very important to peel off the label so that the camera is
perfectly attached to the door(FIG. 1).
2.
Peel off the 3M sticker top layer on the holding plate and fit the holding
plate over the end of the camera wires on to the back of the door. Make
sure the arrow on the holding plate points upwards. Then screw up the
locking barrel on to the back of the camera.This will hold the plate to
the door(FIG.2)
When inserting the camera wire into the socket ,ensure you match the
3.
connectors correctly.(FIG. 3) . The excessive wire should be gently pla-
ced into the groove at the back of the screen.
Warning: it is very important that the connector is perfectly connected
and in the position indicated.
Hook the screen over the bracket at the top of the holding plate and se-
4.
cure with one small screw through the hole at the bottom of the screen.
(FIG. 4).
Cable
connection down
FIG. 1
FIG. 3
13
FIG. 2
HANG
SCREW
FIG. 4

Publicidad

loading