Descargar Imprimir esta página

GreenWorks PS24B00 Manual Del Propietário página 23

Ocultar thumbs Ver también para PS24B00:

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
Polesaw fails to
The poles are not assembled
turn on.
correctly.
No electrical contact between the
polesaw and battery.
The battery pack is depleted.
The lock-off lever and trigger are
not depressed simultaneously.
The battery and power tool is too
hot or too cold.
Bar and chain
No oil in the oil tank.
running hot and
smoking.
The discharge port is blocked by
debris.
Inlet opening in inner oil tank is
blocked by debris.
The sprocket is stuck and
clogged with debris.
The chain and bar
Check chain tension for
running too hot
overtightened or loose condition.
and cannot cut.
Dull chain.
Chain on backwards.
Motor running, but
Motor stops after about 3
cutting abnormal.
seconds.
When using the polesaw under
load, it stops.
Battery is not charged.
Lack of bar and chain lubricant
can cause increased friction.
Chain needs to be properly
maintained.
Incorrect battery storage
temperature.
SOLUTION
Reassemble the poles according to the
instructions.
To secure the battery, make sure the latches
on the battery compartment snap into place.
Charge the battery pack.
Press down the lock-off lever and hold it,
then depress the trigger to turn on the pole
saw.
Refer to the battery and charger
maintenance part in the manual.
Refill oil into the oil tank.
Remove the bar according to the manual
and then clean out the debris.
Clean the oil tank, and refill with clean bar
and chain lubricant.
Clean the sprocket and refill with clean bar
and chain lubricant.
Refer to Re-tensioning the saw chain in the
manual.
Sharpen or replace the chain.
Refer to Replacing the Bar and Chain
assembly earlier in this manual.
Recharge the battery.
Release trigger. Restart the polesaw. Do not
force the polesaw. Refer to the manual for
proper use.
Charge the battery. Refer to the battery
and charger manual for correct charging
procedures.
Make sure the polesaw always has bar and
chain lubricant.
Allow the battery pack to cool until the
temperature drops to room temperature.
23

Publicidad

loading