YATO YT-82196 Manual Original página 11

CHARACTERISTICS OF TOOL
Polisher is a power tool designed for polishing and maintenance of metal surfaces made of metal wood and mineral materials.
It facilitates and accelerates the restoration work. In any case, the tool must not be used for other working materials than those
mentioned above, eg. for grinding and cutting. Correct, reliable, and safe operation of polisher is dependent on the proper opera-
tion, so before using:
Prior to working with the tool, you should read all the instructions and keep it around.
Always use eye protection!
Do not use polishing discs and covers of a maximum allowable peripheral speed of less than 80 m/s!
Do not use polishing discs and covers a maximum authorized rotational speed less than the rotational speed of a tool.
For any damage or injuries caused by failure to comply with safety regulations and instructions of this manual, the supplier is not
responsible.
EQUIPMENT
Polisher is supplied with the following accessories:
- auxiliary handle
- polishing wheel
- cover for polishing wheel
TECHNICAL PARAMETERS
Parameter
Catalogue number
Mains voltage
Mains frequency
Nominal power
Nominal rotation
Diameter of the grinding disk
Spindle end
Mass
Level of noise
- acoustic pressure L ± K
pA pA
- power L ± K
wA wA
Level of vibrations ± K (main / additional handle)
ah,AG
Insulation class
Protection grade
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fi re or injuries. The
notion of electric tool used in the instructions applies to all the tools which are powered with electric current, both wire tools and
wireless ones.
OBSERVE THE FOLLOWING INSTRUCTIONS
Place of work
The place of work must be properly illuminated and clean. Disorder and poor illumination may be a cause of accidents.
Do not work with electric tools in explosive environments, or those which contain infl ammable liquids, gases or vapours.
Electric tools generate sparks, which may cause a fi re in case of contact with infl ammable gases or vapours.
Do not allow children and outsiders to the place of work. A lack of concentration may result in a loss of control over the tool.
Electric safety
The plug of the power supply cable must fi t the mains socket. Do not modify the plug. Do not use any adapters whatso-
ever in order to adapt the plug to the socket. Unmodifi ed plug which fi ts the socket reduces the risk of an electric shock.
Avoid contact with grounded surfaces, such as pipes, heaters and refrigerators. Grounding of the body increases the risk
of an electric shock.
Do not expose electric tools to precipitation or humidity. Water and humidity which gets into the electric tool increases the
risk of an electric shock.
O R I G I N A L
GB
Unit of measurement
[V]
[Hz]
[W]
[min -1 ]
[mm]
[kg]
[dB (A)]
[dB (A)]
[m/s 2 ]
I N S T R U C T I O N S
Value
YT-82196
220 - 240
50
1400
600 - 3500
180
M14
3,15
89,5 ± 3,0
100,5 ± 3,0
1,489 ± 1,5 / 1,785 ± 1,5
II
IPX0
11