Porter Cable C7550 Manual De Instrucciones página 4

All manuals and user guides at all-guides.com
• Exposure to chemicals in dust creat-
ed by power sanding, sawing, grind-
ing, drilling, and other construction
activities may be harmful.
• Sprayed materials such as paint,
paint solvents, paint remover, insec-
ticides, weed killers, may contain
harmful vapors and poisons.
WHAT CAN HAPPEN
• Oil can leak or spill and could
result in fire or breathing hazard;
serious injury or death can result. oil
leaks will damage carpet, paint or
other surfaces in vehicles or trailers.
RISk OF BURSTING
Air Tank: The air tank on your Air Compressor is designed and may be UM coded
(for units with air tanks greater than 6 inch diameter) according to ASME Section
VIII, Div. 1 rules. All pressure vessels should be inspected once every two years.
To find your state pressure vessels inspector, look under the Division of Labor and
Industries in the government section of a phone book.
The following conditions could lead to a weakening of the air tank, and result in a
violent air tank explosion:
WHAT CAN HAPPEN
• Failure to properly drain condensed
water from air tank, causing rust and
thinning of the steel air tank.
• Modifications or attempted repairs to
the air tank.
• Unauthorized modifications to the
safety valve or any other components
which control air tank pressure.
• Excessive vibration can weaken the
air tank of a stationary compressor
and cause an explosion.
1000003897
• Work in an area with good cross
ventilation. Read and follow the safe-
ty instructions provided on the label
or safety data sheets for the materi-
als you are spraying. Always use
certified safety equipment: NIOSH/
OSHA respiratory protection or prop-
erly fit ting face mask designed for
use with your specific application.
HAZARD
RISk OF SERIOUS INjURY OR PROPERTY DAMAGE
WHEN TRANSPORTING COMPRESSOR
• Always place compressor on a
protective mat when transporting
to protect against damage to vehicle
from leaks. Remove compressor
from vehicle immediately upon
arrival at your destination.
HAZARD
• Drain air tank daily or after each use.
If air tank develops a leak, replace it
immediately with a new air tank or
replace the entire compressor.
• Never drill into, weld, or make any
modifications to the air tank or its
attachments. Never attempt to
repair a damaged or leaking air tank.
Replace with a new air tank.
• The air tank is designed to withstand
specific operating pressures.
Never make adjustments or parts
substitutions to alter the factory set
operating pressures.
• The compressor must be properly
mounted, see "Anchoring" under
Installation.
4-ENG
HOW TO PREVENT IT
HOW TO PREVENT IT