Mitsubishi MOTORS MME31504 Manual De Instalación página 6

Operatin Operatin
Operatin Operatin Operatin
The 5452 sensor is designed to indicate all
changes in vehicie position.
GB
lt indicates movements both the longitudinal and
lateral axis.
It can be used io indicate any attempt to steal
the wheels of the veh¡cle or raise and tow it.
The sensor is engaged when the alarm system
is switched on and takes 90 seconds to store
the referenced position of the vehicle.
After this time lapse, ali movements detected
with respect to the stored position generate an
alarm. Fast movements are detected
immediately, while slow oniy when the jacking
up speed is higher then 0.6° per minute.
The vehicle has to be jacked up in exceed of
1.80 to trigger the alarm.
Content of kit Content of kit Content of kit
Content of kit Content of kit
1 5452 sensor
1 strip of bi-adhesive tape
1 connection cabie
1 installation instructions bookiel
Technical specification of sensor Technical specification of sensor Technical specification of sensor Technical specification of sensor Technical specification of sensor
Rated voltage -------------------------------- 12 VDC
Working voltage -------------------------- 9/16 VDC
Input ------------------------------------------ < 4.6 mA
Operating temperature ------------- -40C°/+85C°
Alarm threshold ----------------------- 1,8° +/- 0.4°
Detected speed -------------------------- >0.6°/min
6
06DE2193A Mitsubishi MME31504_segn.pmd
Способ установки
Датчик
горизонтальную поверхность, внутри салона
машины, используя двустороннюю липкую
ленту, входящую в комплект. Сторона датчика
с надписью Sicurtronic должна быть обращена
вверх. Этот датчик может использоваться со
всеми изделиями нашего производства,
выполняя указания, приведенные на рисунках
1-2-3.
6
должен устанавливаться
НАДПИСЬ SICURTRONIC
ДВУСТОРОННЯЯ ЛИПКАЯ ЛЕНТА
13/10/2005, 11.37
на
R
19